Your cart is currently empty!
CPS 5-2-1 CSRU1 Compressor Saver Kit Hard Start Capacitor
$3462
15 in stock
Description
CPS 5-2-1 CSRU1 Compressor Saver Kit Hard Start Capacitor with Relay For 1-2-3 Tons
An air conditioner’s compressor consumes more power on start-up than any other device in the home. In-rush current can damage the compressor’s motor, which may start up more than 10,000 times in a single cooling season.
A 5-2-1® Compressor Saver® significantly reduces the amount of time the compressor is on start-up overload.
The CPS 5-2-1 CSRU1 uses a powerful multi-layer starting capacitor and a smart switch that gives the compressor the boost it needs to start up quickly and draw less power, thus saving your customers money too.
There are only 3 color-coded wires which need to be connected. The Black wire will be connected to the Common side of the compressor. The Striped wire will be connected to the Start winding of the compressor and the Red wire will be connected to the Run winding of the compressor. Remember–5,2,1,=Common, Start, Run.
General Safety Instructions
Only trained and qualified service personnel should install this kit. Most states, countries etc. may require the installer to be licensed. Please check with your local government agency.
Danger-Electrical Shock Hazard
Always disconnect the power source before attempting to install this kit. Failure to do so may result in severe electrical injury or even death.
Caution-Equipment Damage
Failure to properly install this kit can and will cause permanent damage to the compressor and related components.
- CPS 5-2-1 CSRU1 Compressor Saver Kit Hard Start Capacitor
- Extend the life of your compressor
- Reduce damaging in-rush current by up to 50%
- Save homeowners money by using less energy
- Protect vital internal components
- Refrigeration systems
- Start air conditioners that are breaking down
- 1 to 3 ton
CPS 5-2-1 CSRU1 Compressor Saver Kit Hard Start Capacitor | |
Base Unit of Measure : | Unit(S) |
Product Height : | 6 IN |
Product Width : | 1.8 IN |
Gross Weight : | 0.7 LB |
Hertz : | 60 hz |
Product Length : | 6 IN |
Wires : | 3 |
Max Torque : | 1 Tons - 3 Tons |
Accessory Type : | Start Kit |
No product questions available.
- No product manuals available.
No product videos available.
- (1) CPS 5-2-1 CSRU1 Compressor Saver Kit CSRU1 Hard Start Capacitor with Relay For 1-2-3 Tons
I haven't installed the kit yet, as I am awaiting a Clamp On Meter I purchased to arrive, so that I can measure the Insrush Amps with a Before and After Install reading. I fully expect the kit to do the job of giving our compressor additional time of service based on everything I have read and all of the videos I have watched on YouTube. I purchased the kit from HVAC & Tools Direct who promptly fulfilled my order at a good price. I will purchase from them in the future as a reliable supplier of anything related to HVAC supplies and equipment.
I used this on a unit that had been condemned as locked rotor...3 ton unit and it would not stat, at first...This system kicked it off immediately...Ran it for a while, stopped it, let it equalize and hit it again...Did this several times..Fast start every time...I was treated like a hero, felt like one too...These work.
CPS 5-2-1 CSRU1 Compressor Saver Kit Hard Start Capacitor
Related products
-
Yellow Jacket 69020 Omni Digital Vacuum Gauge with 1/4 Coupler
$20332 Add to cart -
AmRad Run Capacitor USA2221B 60 + 7.5 uf MFD 370/440 Volt
$4152 Add to cart -
AmRad Run Capacitor USA2218A 55 + 7.5 uF MFD x 370/440 Volt
$3840 Add to cart -
AmRad Run Capacitor USA2218BA 55 + 10 uf MFD 370/440 Volt
$4080 Add to cart