Your cart is currently empty!
Veto Pro Pac DH2 Large Drill Holster
$12995
Brand: Veto Pro Pac GTIN#: 810111060141 MPN#: VPP10517
22 in stock
Description
The Veto Pro Pac DH2 Large Drill Holster brings additional features to a drill holster. The exterior sides of the DH2 integrate 6 small pockets perfect for 2-4” bits, extensions, and/or nut drivers. A horizontal strip of webbing along the top provides an easy-to-reach perch for short driver tips as well as storing the safety lanyard clip while working at ground level. A slot behind the front panel is a handy location to clip a tape measure. The DH2 offers two options for attaching itself to a belt or tool bag: a belt pass-through or the option to add our stainless steel Repositionable Belt Clip (sold separately, NOT INCLUDED WITH DH2) to the vertical molle on the rear. The DH2 includes a unique bottom flap that secures closed to either protect a drill chuck/driver bit or allow the holster volume to instead store various hand tools or spare parts. When left open long bits and extensions can extend through and the open flap provides additional protection to the hip from a sharp bit.
- Made in USA
- Rugged construction & aluminum hardware
- Belt Pass-through
- Bottom flap closes to protect chuck / opens for long bit clearance
- 6 External pockets for bits, extensions, and nut drivers
- 4 1” Bit holders
- Safety lanyard
- Tape measure clip
- Warranty: 5 Years (see Veto warranty terms and conditions)
1
How To Keep the Zippers Clean & Lubricated?
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
How To Protect the Zippers From Sharp Objects and/or Excessive Heat?
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
How To Don’t Overstuff the Bag?
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!
- (1) DH2 Large Drill Holster VPP10517
