Your cart is currently empty!
Veto Pro Pac MB-TTXL Extra Large Open Tote Tool Bag w/Rubber Base
$20995
Description
The Veto Pro Pac MB-TTXL is an X-Large Open Tool Tote with a Rubber Base. The MB-TTXL is a wider version of the MB-TT tool tote, with a non-marking rubber bottom, is designed for Builders, General Contractors or any tradesman or technician to store hand tools on the inside pockets and bulk storage capacity in the middle. This tool organizer is also designed to accommodate Boat Builders and Shipwrights to store, carry and access all of their tools.
- Maximized Tool Storage Capacity
- 2 Interior, Removable Pocket Panel Sleeves, Totaling 20 Pockets
- 32 Exterior Vertical Tool Pockets
- Polypropylene bottom over-molded with non-marking TPR Rubber
- Stainless Steel Tape Measure Clip
- Rugged Materials & Construction
- Polyester Canvas Body Fabric
- Leather Grips and Trim
- Other Features
- Warranty: 5 Years (see Veto warranty terms and conditions)
| Height : | 13" (33cm) |
| Width : | 16.5" (42cm) |
| Depth : | 9” (23cm) |
| Weight (empty) : | 7.5lbs (3.5kg) |
| Max Payload : | 45lbs (20kg) |
| Internal Volume : | 1870in3 (30.5L) |
How to keep the Zippers Clean & Lubricated?
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
How to protect the Zippers From Sharp Objects and/or Excessive Heat?
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
How to not Overstuff the Bag?
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!
- (1) Veto Pro Pac MB-TTXL
